Copper Repiping Tips

Why Copper Repiping? You might ask. Copper is a carefree metal, which is able to last a lifetime.  This property allows utilization of copper to be very common in business and in homes for years now. There are two types of copper; that is, in form of a soft coil which is several feet in a roll. The other type is in a ridged form it is hard and does not bend. It comes in sticks that go up to 10 feet. The ridged type of copper is commonly used in the water lines.

When your water system is experiencing leaks or it’s worn out, you need to replace it. Galvanized steel pipes were used in older homes; as a result, with time the pipes tend to develop leaks and rusty spots. When this happens the piping system is bristle and you cannot repair it, you will need to replace it. When replacing, you can use copper as it has been service tested.

Copper Repiping requirement

• First turn off the main water valve, drain the water in the piping system
• Then remove the existing piping system, in the event that you are not going to reuse the existing piping, you can cut it into little pieces. This will make it easy for you to handle, make the cuts at the corners, therefore, saving on the damages to be made on the walls or ceiling.
• In the areas where there was eradication of the pipes in order to place new pipes in the area, hire a professional or you can measure the project
• Ensure that the diameter of the pipe is big enough, so as to have adequate water pressure in your home.
• If you are using copper ¾ inch, main lines ought to be branched down to a half an inch line that is going to the faucet or valve. Figure out the estimates of pipes plus their sizes that you will require.
• Then know the fittings that you will need, that is from; unions, reducers, elbows and cross tees among others.
• You also must have plumb safe solder, flux and steel wool as a torch, pipe cleaner and for cleaning the ends of the fittings and pipes respectively.

Copper repiping process involves cleaning of the parts to bright coppery shine, when fusing the copper fittings. To the pipe and the fitting add some flux then heat fitting up. When you touch the fusion of the pipe that is close to the fitting in question, if it sucks into the fitting or melts then it’s hot enough.

If you have a repiping problem, our repiping Guide is all that you need to get the information that will solve your problem. With our Repiping Guide you will be able to get information, tricks, tutorial and tips necessary for copper repiping job.